Control Transformer Synchro

Features

Specifications

• Body Material:
  Steel, stainless
• Body Style:
  Standard round c
• Shoulder Diameter:
  Between 1.3115 inches and 1.3120 inches
• Pilot Diameter:
  Between 0.8745 inches and 0.8750 inches
• Flange Diameter:
  Between 1.4320 inches and 1.4370 inches
• Flange Thickness:
  0.0930 inches
• Undercut Diameter:
  1.3120 inches
• Undercut Width:
  0.0780 inches
• Shaft Diameter:
  0.1870 inches single shaft and 0.1872 inches single shaft
• Shaft Length:
  0.5400 inches single shaft
• Maximum Tempurature Rise:
  10.0 degrees celsius
• Body Size:
  15
• Stator Input Voltage Rating In Volts:
  90.0
• Stator Input Current Rating:
  10.0 milliamperes
• Stator Input Electrical Power Rating:
  140.0 milliwatts
• Frequency In Hertz:
  400.0
• Zso Impedance Magnitude In Ohms:
  Between 7800.00 and 9512.00
• Zso Impedance Angle In Deg:
  Between 77.80 and 84.50
• Zrs Impedance Magnitude In Ohms:
  Between 1050.00 and 1300.00
• Zrs Impedance Angle In Deg:
  Between 26.00 and 33.00
• Phase Shift Angle In Deg:
  5.500 input to output
• Maximum Fundamental Null Voltage In Millivolts Per Volt:
  32.00 output
• Maximum Total Null Voltage Output In Millivolts Per Volt:
  60.00
• Electrical Error Angular Range In Minutes:
  -6.0/+6.0
• Electrical Error Angular Range In Minutes:
  -6.0 to 6.0
• Spline Tooth Quantity:
  21 single shaft
• Torque Gradient Per Angular Deg:
  0.050 inch-ounces
• Alignment Hole Quantity:
  4
• Pilot Length:
  0.0400 inches
• Shoulder Length:
  0.1320 inches
• Mounting Surface To Terminal End Distance:
  1.7720 inches
• Spline Tooth Diametral Pitch:
  120 single shaft
• Shaft Thread Series Designator:
  Unf single shaft
• Shaft Thread Direction:
  Right-hand single shaft
• Shaft Thread Class:
  2a
• Shaft Thread Class:
  2a single shaft
• Terminal Location:
  Rear
• Shaft Thread Length:
  0.1850 inches single shaft
• Shaft Type:
  Spline w/threads single shaft
• Alignment Hole Depth:
  0.1250 inches
• Transformation Ratio:
  0.735 rotor to stator
• Alignment Hole Bolt Circle Diameter:
  1.1000 inches
• Shaft Thread Size:
  0.190 inches single shaft
• Test Data Document:
  81349-mil-s-20708 specification (includes engineering type bulletins, brochures, etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "", etc.).
• Terminal Type And Quantity:
  5 screw
• Specification Data:
  81349-mil-s-20708/15 government specification
• Federal Supply Class (fsc):
  Synchros and resolvers
• National Stock Number (nsn):
  5990-00-068-4324