Control Transformer Synchro

Features

Specifications

• Body Material:
  Steel, corrosion resisting
• Body Style:
  Standard round b
• Shoulder Diameter:
  Between 1.3070 inches and 1.3120 inches
• Pilot Diameter:
  Between 0.8745 inches and 0.8750 inches
• Flange Diameter:
  Between 1.4320 inches and 1.4370 inches
• Flange Thickness:
  Between 0.0880 inches and 0.0980 inches
• Undercut Width:
  Between 0.0730 inches and 0.0830 inches
• Shaft Diameter:
  0.1870 inches and 0.1872 inches single shaft
• Shaft Length:
  0.5450 inches and 0.5650 inches single shaft
• Maximum Tempurature Rise:
  10.0 degrees celsius
• Body Size:
  15
• Stator Input Voltage Rating In Volts:
  90.0
• Stator Input Current Rating:
  13.0 milliamperes
• Stator Input Electrical Power Rating:
  210.0 milliwatts
• Frequency In Hertz:
  60.0
• Zso Impedance Magnitude In Ohms:
  6250.00
• Zso Impedance Angle In Deg:
  Between 76.00 and 84.00
• Zrs Impedance Magnitude In Ohms:
  1475.00
• Zrs Impedance Angle In Deg:
  Between 12.00 and 20.00
• Phase Shift Angle In Deg:
  9.000 input to output
• Maximum Fundamental Null Voltage In Millivolts Per Volt:
  50.00 output
• Maximum Total Null Voltage Output In Millivolts Per Volt:
  100.00
• Electrical Error Angular Range In Minutes:
  -10.0 to 10.0
• Spline Tooth Quantity:
  21 single shaft
• Actuator Friction Torque At Plus 25 Deg Celsius:
  0.05 inch-ounces
• Alignment Hole Quantity:
  4
• Shaft Radial Play Test Point:
  0.125 inches
• Shaft Maximum Radial Play:
  0.0006 inches
• Shaft End Play:
  Between 0.0005 inches and 0.0015 inches
• Pilot Length:
  Between 0.0350 inches and 0.0450 inches
• Shoulder Length:
  Between 0.1070 inches and 0.1270 inches
• Mounting Surface To Terminal End Distance:
  2.5180 inches
• Spline Tooth Diametral Pitch:
  120 single shaft
• Shaft Thread Series Designator:
  Unf single shaft
• Shaft Thread Direction:
  Right-hand single shaft
• Shaft Thread Class:
  2a single shaft
• Terminal Location:
  Rear
• Shaft Thread Length:
  0.2000 inches single shaft
• Shaft Type:
  Spline w/threads single shaft
• Alignment Hole Depth:
  0.1250 inches
• Transformation Ratio:
  0.735 rotor to stator
• Alignment Hole Bolt Circle Diameter:
  Between 1.0970 inches and 1.1030 inches
• Shaft Thread Size:
  0.190 inches single shaft
• Shaft Radial Play Determining Weight:
  8.0 ounces
• Shaft End Play Determining Weight:
  16.0 ounces
• Terminal Type And Quantity:
  5 screw
• Federal Supply Class (fsc):
  Synchros and resolvers
• National Stock Number (nsn):
  5990-01-213-6319