Control Transformer Synchro

Features

Specifications

• Body Material:
  Steel, corrosion resisting
• Body Style:
  Standard round c
• Shoulder Diameter:
  Between 1.5615 inches and 1.5620 inches
• Pilot Diameter:
  Between 0.9370 inches and 0.9375 inches
• Flange Diameter:
  Between 1.7470 inches and 1.7500 inches
• Flange Thickness:
  Between 0.0900 inches and 0.0960 inches
• Undercut Diameter:
  Between 1.6220 inches and 1.6280 inches
• Undercut Width:
  0.0780 inches
• Shaft Diameter:
  0.1870 inches single shaft and 0.1872 inches single shaft
• Shaft Length:
  0.3790 inches single shaft and 0.3870 inches single shaft
• Schematic Diagram Designator:
  1 y-rotor, 1 stator
• Fragility Factor:
  Moderately rugged
• Body Size:
  18
• Stator Input Voltage Rating In Volts:
  90.0
• Stator Input Current Rating:
  7.0 milliamperes
• Stator Input Electrical Power Rating:
  100.0 milliwatts
• Frequency In Hertz:
  400.0
• Zso Impedance Magnitude In Ohms:
  13000.00
• Zso Impedance Angle In Deg:
  88.00
• Rotor Dc Resistance In Ohms:
  420.00
• Stator Dc Resistance In Ohms:
  675.00
• Phase Shift Angle In Deg:
  3.000 input to output
• Maximum Fundamental Null Voltage In Millivolts Per Volt:
  30.00 output
• Maximum Total Null Voltage Output In Millivolts Per Volt:
  45.00
• Electrical Error Angular Range In Minutes:
  -6.0/+6.0
• Spline Tooth Quantity:
  21 single shaft
• Actuator Friction Torque At Plus 25 Deg Celsius:
  0.10 inch-ounces
• Alignment Hole Quantity:
  4
• Shaft Radial Play Test Point:
  0.125 inches
• Shaft Maximum Radial Play:
  0.0008 inches
• Shaft End Play:
  0.0030 inches
• Pilot Length:
  0.0370 mils and 0.0430 centimeters
• Shoulder Length:
  0.1290 mils and 0.1350 centimeters
• Mounting Surface To Terminal End Distance:
  2.5230 inches
• Spline Tooth Diametral Pitch:
  120 single shaft
• Shaft Maximum Runout:
  0.0008 inches
• Shaft Thread Series Designator:
  Unf single shaft
• Shaft Thread Direction:
  Right-hand single shaft
• Shaft Thread Class:
  2a single shaft
• Terminal Location:
  Rear
• Shaft Thread Length:
  0.3550 inches single shaft
• Shaft Type:
  Spline w/threads single shaft
• Alignment Hole Depth:
  0.1250 inches
• Transformation Ratio:
  0.735 rotor to stator
• Alignment Hole Bolt Circle Diameter:
  1.2500 inches
• Shaft Thread Size:
  0.190 inches single shaft
• Shaft Radial Play Determining Weight:
  16.0 ounces
• Shaft End Play Determining Weight:
  16.0 ounces
• Terminal Type And Quantity:
  5 screw
• Federal Supply Class (fsc):
  Synchros and resolvers
• National Stock Number (nsn):
  5990-00-078-3182