Differential Transmitter Synchro

Features

Specifications

• Body Material:
  Steel, corrosion resisting
• Body Style:
  Standard round c
• Shoulder Diameter:
  Between 0.9995 inches and 1.0000 inches
• Pilot Diameter:
  Between 0.6245 inches and 0.6250 inches
• Flange Diameter:
  Between 1.0570 inches and 1.0620 inches
• Flange Thickness:
  0.0930 inches
• Undercut Diameter:
  0.9750 inches
• Undercut Width:
  0.0620 inches
• Shaft Diameter:
  0.1872 inches single shaft
• Shaft Length:
  0.5550 inches single shaft
• Fragility Factor:
  Moderately rugged
• Maximum Tempurature Rise:
  20.0 degrees celsius
• Body Size:
  11
• Stator Input Voltage Rating In Volts:
  90.0
• Stator Input Current Rating:
  49.0 milliamperes
• Stator Input Electrical Power Rating:
  530.0 milliwatts
• Frequency In Hertz:
  400.0
• Zso Impedance Magnitude In Ohms:
  Between 1590.00 and 2050.00
• Zso Impedance Angle In Deg:
  Between 79.00 and 85.00
• Zrs Impedance Magnitude In Ohms:
  Between 470.00 and 570.00
• Zrs Impedance Angle In Deg:
  Between 23.00 and 33.00
• Phase Shift Angle In Deg:
  4.000 input to output
• Maximum Fundamental Null Voltage In Millivolts Per Volt:
  60.00 output
• Maximum Total Null Voltage Output In Millivolts Per Volt:
  90.00
• Electrical Error Angular Range In Minutes:
  -7.0/+7.0
• Electrical Error Angular Range In Minutes:
  -7.0 to 7.0
• Spline Tooth Quantity:
  21 single shaft
• Actuator Friction Torque At Plus 25 Deg Celsius:
  0.07 inch-ounces
• Alignment Hole Quantity:
  4
• Pilot Length:
  0.0620 inches
• Shoulder Length:
  0.0620 inches
• Mounting Surface To Terminal End Distance:
  1.8510 inches
• Spline Tooth Diametral Pitch:
  120 single shaft
• Shaft Thread Series Designator:
  Unf single shaft
• Shaft Thread Direction:
  Right-hand single shaft
• Shaft Thread Class:
  2a
• Shaft Thread Class:
  2a single shaft
• Terminal Location:
  Rear
• Shaft Thread Length:
  0.2000 inches single shaft
• Shaft Type:
  Spline w/threads single shaft
• Alignment Hole Depth:
  0.1250 inches
• Transformation Ratio:
  1.154 rotor to stator
• Alignment Hole Bolt Circle Diameter:
  0.8120 inches
• Shaft Thread Size:
  0.190 inches single shaft
• Test Data Document:
  81349-mil-s-20708 specification (includes engineering type bulletins, brochures, etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "", etc.).
• Terminal Type And Quantity:
  6 screw
• Specification Data:
  81349-mil-s-20708/81 government specification
• Federal Supply Class (fsc):
  Synchros and resolvers
• National Stock Number (nsn):
  5990-00-179-1871